XU Zhe, WEI Min-xiang, LI Yu-fang. Variation characteristic of wheel cylinder pressure in electro-hydraulic braking system controlled by PWM signal[J]. Journal of Traffic and Transportation Engineering, 2013, 13(1): 55-61. doi: 10.19818/j.cnki.1671-1637.2013.01.009
Citation: XU Zhe, WEI Min-xiang, LI Yu-fang. Variation characteristic of wheel cylinder pressure in electro-hydraulic braking system controlled by PWM signal[J]. Journal of Traffic and Transportation Engineering, 2013, 13(1): 55-61. doi: 10.19818/j.cnki.1671-1637.2013.01.009

Variation characteristic of wheel cylinder pressure in electro-hydraulic braking system controlled by PWM signal

doi: 10.19818/j.cnki.1671-1637.2013.01.009
More Information
  • Author Bio:

    XU Zhe(1983-), male, doctoral student, +86-25-84892201, bluesky@nuaa.edu.cn

    WEI Min-xiang(1963-), male, professor, +86-25-84892201, weimx@nuaa.edu.cn

  • Received Date: 2012-07-21
  • Publish Date: 2013-02-25
  • In order to decrease the variation amplitude of wheel cylinder pressure for electro-hydraulic braking system(EHB), the pressure variation rate was represented by the stable pressure variation value, and the variation law in the working range was investigated. The formula to calculate the stable pressure variation value was deduced, some experiments were carried out to measure the stable pressure variation values under different initial pressures and duty cycles. Calculation result shows that the curves of the rates have inflection points according to the initial pressures. At the left side of every inflection point, the pressure variation rate increases with the increase of initial pressure. While at the right side, the rate decreases. The inflection points at different duty cycles appear at the nearly same cylinder pressure. As the inflection point is caused by piston motivation, it is named as piston motivation's end pressure. In the system, it is about 2.9 MPa. The relationship between the pressure rate and the duty cycle is approximate linear in working pressure range.

     

  • loading
  • [1]
    SCHENK D E, WELLS R L, MILLER J E. Intelligent braking for current and future vehicles[C]//SAE. SAE International Congress and Exposition1995. Detroit: SAE, 1995: 43-46.
    [2]
    NISHIMAKI T, YUHARA N, SHIBAHATA Y, et al. Two-degree-of-freedom hydraulic pressure controller design for direct yaw moment control system[J]. JSAE Review, 1999, 20(4): 517-522. doi: 10.1016/S0389-4304(99)00041-7
    [3]
    YOU S H, HAHN J O, CHO Y M, et al. Modeling and control of a hydraulic unit for direct yaw moment control in an automobile[J]. Control Engineering Practice, 2006, 14(9): 1011-1022. doi: 10.1016/j.conengprac.2005.06.002
    [4]
    JONNER W D, WINNER H, DREILICH L, et al. Electro hydraulic brake system—the first approach to brake-by-wire technology[C]//SAE. SAE International Congress and Exposition1996. Detroit: SAE, 1996: 105-112.
    [5]
    AHN J K, JUNG K H, KIM D H, et al. Analysis of a regenerative braking system for hybrid electric vehicles using an electro-mechanical brake[J]. International Journal of Auto-motive Technology, 2009, 10(2): 229-234. doi: 10.1007/s12239-009-0027-z
    [6]
    PETRUCCELLI L, VELARDOCCHIA M, SORNIOTTI A. Electro-hydraulic braking system modelling and simulation[C]//SAE. SAE21st Annual Brake Colloquium and Exhibition. Hollywood: SAE, 2003: 1-8.
    [7]
    HONG D, HWANG I, YOON P, et al. Development of a vehicle stability control system using brake-by-wire actuators[J]. Journal of Dynamic Systems, Measurement, and Control, 2008, 130(1): 1-9.
    [8]
    QI Xue-le. Research on dynamic response of ABS hydraulic brake system and development of integrated platform for simulating matching[D]. Beijing: Tsinghua University, 2005. (in Chinese).
    [9]
    SHA Hong-liang. Research on ESP's control algorithm for light vehicle based on the estimation of wheel cylinder pressure[D]. Changchun: Jilin University, 2008. (in Chinese).
    [10]
    YU Liang-yao, WANG Hui-yi, SONG Jian, et al. Performance evaluation and test of anti-lock braking system hydraulic system[J]. Chinese Journal of Mechanical Engineering, 2007, 43(9): 40-46. (in Chinese). http://www.cnki.com.cn/Article/CJFDTOTAL-JXXB200709011.htm
    [11]
    JEONG H S, KIM H E. Experimental based analysis of the pressure control characteristics of an oil hydraulic three-way on/off solenoid valve controlled by PWM signal[J]. Journal of Dynamic Systems, Measurement, and Control, 2002, 124(1): 196-205. doi: 10.1115/1.1433483
    [12]
    LI Zhi-yuan, LIU Zhao-du, CUI Hai-feng, et al. Experimental study on change rate model of brake pressure of ABS wheel cylinder[J]. Transactions of the Chinese Society for Agricultural Machinery, 2007, 38(9): 6-9. (in Chinese). http://www.cnki.com.cn/Article/CJFDTOTAL-NYJX200709004.htm
    [13]
    GUO Kong-hui, LIU Li, DING Hai-tao, et al. A study on hydraulic characteristics of anti-lock braking system[J]. Journal of Jilin University of Technology: Natural Sciences, 1999, 29(4): 1-5. (in Chinese). http://www.cnki.com.cn/Article/CJFDTOTAL-JLGY199904000.htm
    [14]
    WANG Ji-hua, WEI Min-xiang, DU Yan-li, et al. H∞ robust control of multi-steering vehicle based on T-S fuzzy model[J]. Journal of Traffic and Transportation Engineering, 2012, 12(4): 42-49. (in Chinese). http://transport.gfscw.cn/article/id/201204006

Catalog

    Article Metrics

    Article views (2140) PDF downloads(790) Cited by()
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return